|WARNING: Removing the old style K-probe with the white insulating sleeve should only be done if absolutely necessary. It is very easy to damage the probe's conductors as they are made from a thin, single, solid-core wire and are somewhat brittle. Avoid unnecessarily bending the wires, particularly on a small radius. It is easy to damage the small conductors inside the plug when compressing their retaining tabs and pulling them from the plug. Be sure to make note of the polarity as the wires MUST go back in the same way they came out.|
DISCLAIMER: These video presentations are not intended to be all-inclusive instructional videos nor offer advice on appliance repair. They merely illustrate the process. These videos take a lot for granted such as, but not limited to, safety around electrical devices, proper choice and use of hand tools, techniques to ensure personal safety, protection of property, fire safety, and more. By viewing. listening to, or watching this or any other video on the Hottop USA website you assume all responsibility and release Hottop USA and all its employees and contractors from any and all liability. If you do not accept these terms and/or your local laws prohibit such a release of liability, you may not watch or use the information in these videos.NOTE: This video is for the old style K-probe with the larger, white insulating sleeve. The newer probes have a covering that is much smaller in diameter. To remove the new probe unplug it from teh control panel, unscrew the locknut, slide the nut and washer off the wire, and remove the probe through the roast chamber. There is NO NEED to remove the plug from the wire.
|Installation is in the reverse order of removal:|